特點介紹：

1、系統壓力均不低于17.5Mpa，設備運行高效節能。
The system pressure is not lower than 17.5Mpa,ａnd the equipment runs efficiently and saves energy.
2、公司專門的高射速加大油路設計，射速200mm／s左右，設備運行穩定并且低阻低噪音。開合模周期控制在3秒左右，開模位置重復精度偏差小于1.5mm。
The company's special high firing rate and increased oil circuit design,firing rate of about 200mm/s, stable equipment operation.low resistance and low noise.The mold opening and closing period should be controlled at about 3 seconds. and the deviation ofrepeated precision of mold opening position should be less than 2mm.
3、大螺桿高轉速配置，的提高塑化效率，提升注射速率，的縮短模生產周期。
The configuration of large screw with high rotation speed can maximize plasticizing efficiency,increase injection rate andshorten mold production cycle.
4、標配高速機電腦和高響應電磁閥，標配歐普康電子尺，以確保系統響應速度及精度。
The standard configuration includes the Meng Li high-speed machine computer and the northern precision machine solenoidvalve.The standard configuration includes the Oupukang electronic ruler to ensure the system response speed and accuracy.
5、料筒加熱標配陶瓷加熱圈，螺桿塑化設計具有高效率、高混色及高耐磨性。As standard,Easton computer and Heithecker oil pump.oil research and North Seiki solenoid valves, and Opcom electronicruler are standard to ensure the accuracy of system response speed.
6、標配油溫檢測顯示和機械手、針閥接線端子排。
Standard oil temperature detection and display.terminal block of manipulator and needle valve.